Pool Repair Services

pipe refurbishment  drinking water lines 

Swimming Pool Repairs,​pipe refurbishment in uae

Pool Repair Services POOL REPAIR,POOL REFURBISHMENT PIPE RESTORATION has been specifically developed as a 100% solids lining for the internals of pipes, tanks, vessels and other equipment in contact with potable water.
 Epoxy Coating  combines good application characteristics with excellent corrosion protection and chemical resistance Epoxy Coating  is designed for application in a single high build coat by plural feed hot airless spray and has international approvals for contact with potable water.
To comply with the conditions of approval under Regulation 31(4)(a), this product must be applied in accordance with the approved Instructions For Use Document available from the  on request.
Product Features Suitable for use on steel surfaces and cement mortar lined pipes. Adhesion — Excellent to both blast cleaned and mechanically scraped surfaces. Corrosion Resistance — Excellent even under aggressive immersion conditions. Temperature Resistance — Suitable for use up to 60°C in immersion service conditions dependent on chemicals involved and up to 120°C in dry service conditions. Each site and project will have different needs and pose different challenges, but the overall process of applying the epoxy Lining System is as follows;
Information is collated in order to generate a provisional quote which is subject to a site survey.
A site survey will be carried out to assess access and suitability of the system. Following go ahead, a date of action will be specified and equipment and technicians will assemble on site.
Some work, in advance, to drain the pipe runs in question and disconnect pipework in the plant room will be required by others.
Pressure test carried out to confirm issues with the identified pipe runs/systems.
If required, camera inspection performed to assess for severity of damage (note: large splits, cracks or openings may not be solvable and will require pipe replacement by others).
ePIPE equipment is connected to the circulation system.
An approved aggregate is fired down the pipe run to clean and scour, leaving a key for the ePIPE epoxy resin to bond too.
The pipe run is cleaned and warmed with blasts of hot air


technical specification
​
Part A: Thixotropic liquid epoxy (white) Part B: Thixotropic liquid amine (blue or black) Solids Content 100% solids VOC Content 0 g/L per EPA Method 24 Typical Film Thickness Wet/Dry 20 mils (500 micron) Note: The thickness to be applied should be agreed upon between the specifier and the manufacturer dependant on operational performance criteria. For NSF certified applications the maximum approved thickness is 40 mils (1mm). Calculated Coverage Rate 2 square meters per liter at 500 micron dft. 21.5 square feet per liter at 20 mils dft. Drinking Water Approvals Cold water approvals (23 deg C): AFNOR XP P 41-256, ARPAL, AS/NZS 4020, NSF/ANSI 61, OTEC, Reg 31(4)a, WRAS (Blue ) Hot water approvals (60 deg C): WRAS (Gray only) Cure Times at 20°C (68°F) Pot (usable) Life: 30 minutes Touch Dry: 4 hours Hard Dry: 6 hours (approximately 1 hour when surface temperature is 122°F
​

Picture
Picture


WATER LEAK NOISE identifier
Identify areas of high leakage in water distribution networksNOISE IDENTIFIER for quickly identifying water leaks in distribution networks

water leak detection most likely the best leak detection company in the uk and uae

Portable Correlation with Ground Microphone capabilities to find water leaks in water networks

WATER LEAK LOCATION - TRACER GAS
Find water leaks in houses, central heating systems and water distribution networks

pipe tracer including plastic pipes Pipe, Cable, Camera and Sonde Locator and Tracer

dubai leak detection ,pool leaks , pipe leaks, spa leaks , utilities , pool refurbishment dubai
Picture

    water leak detection Leak detection – In most countries water is a scarce and valuable resource that requires expensive treatment and purification. Water loss comes at a significant cost both in terms of money for the water companies and shortages for society and commercial interests. 247services  was founded in 1998 and is the uk market leader in the area of leak detection. We have the resources and the know-how to carry out large investigations both on a local and international basis. Energy companies, counties, construction companies, housing cooperatives and building service companies are among the customers that utilize 247 SERVICES comprehensive leak detection solutions. Our consultants are proficient in detecting leaks in several areas such as district heating systems, water pipes and roofs, and detect the source of the leakage without damaging the surrounding material. We are truly leak detection professionals and our consulting engineers investigate the source of the leakage regardless of what and where it leaks. Having information about the source of the leak offers our customers the information they need to take proper action and repair the leak. 247 services offers: • Localization of leakages in all pressurized pipes such, as district heating systems.
    • Thermographical investigations for water and energy leakage in district heating systems.
    • Sound ranging and electro-acoustic water leak detection of feed pipes to identify cold water leaks.
    • Project based leak detection and risk analysis for commercial industries and power plants.
    commerical swimming pool and spas leaks found and repaired 
    follow links to our leak detection page
    ​

    please fill your enquiry out we will be happy to advise you
Web Analytics